User Manual

1
2
3
4
5 6
EN
7
ASSEMBLY
BEFORE YOU BEGIN
NEVER point the spray gun at any part of the
body.
TO ASSEMBLE
IMPORTANT: Make sure the power cord is unplugged.
1. Insert the suction tube into the intake opening.
2. Align the suction tube -
a. If you are going to be spraying in a downward direction, the angled
end of the suction tube should be pointing toward the front of the
nozzle.
b. If you are going to be spraying in an upward direction, the angled
end of the suction tube should be pointing toward the rear of the
nozzle.
i
Make sure the suction tube is inserted as far as it will go
to ensure a tight t.
3. Carefully screw the cup back onto the nozzle assembly. Tighten
rmly.
4. Align the arrow on the nozzle with the “unlock” symbol on the
spray gun handle.
5. Insert and twist the nozzle into the handle toward the “lock”
symbol on the handle. The tab below the trigger will lock the two
pieces into place.
6. Insert the air hose tightly into the air hose port in the Power Box.
7. Turn the Power Box switch ON (I). Turn switch on handle to ON (I).
The turbine will not run until handle switch is set to ON (l).
i
Do not pull trigger at any time if the turbine is not
running.