User Manual

EN
9
SPRAY PATTERN ADJUSTMENT
ADJUST SPRAY SHAPE
i
The spray pattern shape is adjusted by turning the adjustment ring (iSpray) or air cap ears (Control Finish) to either the
vertical, horizontal, or diagonal positions. The positions of the air cap and the corresponding spray pattern shapes are
illustrated below.
Test each pattern and use whichever pattern is suitable for your application.
NEVER trigger the gun while adjusting the ears on the air cap. NEVER point the spray gun at any part of the
body.
ADJUSTMENT
RING iSPRAY
Horizontal pattern
=
=
=
 Use ‘up and down’ spraying motion
AIR CAP EARS
CONTROL
FINISH
Vertical pattern
=
=
=
 Use ‘side to side’ spraying motion
IMPORTANT: When changing the spray
pattern, make sure the black retaining ring
is not loosened.
Diagonal pattern*
=
=
=
 Use ‘up and down’ or ‘side to side’ spraying motion
 Use lower air power / material ow
 For coating smaller areas, corners and edges
i
*The air cap can be set diagonally on the Control Finish nozzle only. To achieve a round pattern with the iSpray nozzle,
see the “Adjust Spray Width” section.
ADJUST SPRAY WIDTH  iSPRAY ONLY
The spray width lever on the iSpray nozzle determines the width of the spray pattern.
Spray width lever
ISPRAY
Wide pattern
 For coating large surfaces
 Use higher air power
 Use higher material ow
Narrow pattern
 For coating smaller areas, corners and edges
 Use lower air power
 Use lower material ow
TIPS:
1. Start with a fan pattern for painting trim work (1-5” width) and larger surfaces like doors and walls (>5” width).
2. Adjust Material & Air Flow settings as shown in chart based on coating, fan pattern width, and nozzle.
3. Fine tune the Material and Air Power settings to achieve the best results for your application.
4. Use narrow pattern for detailed work, touch up.
5. Recommended settings for Material and Air Power may change if the coating is thinned.