User manual
16
W14/W15/W16
EN
WARNING UK ONLY
Your unit has been supplied with a supply cord and a tted plug. This is identied by the
fuse holder in the base of the plug. Please read the following safety instructions before use.
1. If the tted plug is cut o from the supply cord then the plug must be disposed of safely.
2.
NEVER under any circumstances insert such a plug into a 13 Amp socket-outlet.
3.
NEVER under any circumstances use the appliance or supply cord without the fuse
cover tted. This is the little cover xed into the base of plug to hold the fuse in place.
4. If you lose the fuse cover then please contact any electrical dealer for a replacement or
ring our helpline above.
5. A replacement fuse must be rated at 13 Amps and approved to BS1362.
IF IN ANY DOUBT PLEASE CONSULT A QUALIFIED ELECTRICIAN.
If you need to t a plug to the supply cord, this should be tted in accordance with the
wiring instructions below, and will need to be used with a 13 Amp fuse. If in doubt consult a
qualied electrician.
WARNING - THlS APPLIANCE MUST BE EARTHED. If you are using an extension
lead it must be rated a minimum of 10 Amps and fully unwound. Do not operate with a
cord rated less than 10 Amps as this will cause premature failure of the element which is not
covered by the guarantee. As the colours of the wires in the supply cord of this appliance
may not correspond with the coloured markings identifying the terminals in your plug,
proceed as follows:
The wire which is coloured green and yellow
must be connected to the terminal in the
plug which is marked with the letter E or by
the earth symbol, or coloured green.
The wire which is coloured blue must be
connected to the terminal which is marked
with the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal which is marked with
the letter L or coloured red.