Use and Care Manual
11
EN
SHRINK WRAPPING
Wrap the object with heat-shrinkable plastic lm. Begin to heat the lm from a safe distance
while keeping the hot tool moving. Move the hot tool closer to the lm until the lm starts to
shrink and tightens around the object.
CLEANING AND MAINTENANCE
Make sure the heat tool is turned OFF (0), the power cord is unplugged, and the heat
tool has suciently cooled before cleaning.
Keep the intake openings on the housing clean and free of obstructions. Us a soft, dry brush to
clean the openings periodically. Use only mild soap and a damp cloth to clean the heat gun.
Many household cleaners contain chemicals which could seriously damage the housing.
Do not use gasoline, turpentine, lacquer or paint thinner, dry cleaning uids or similar products
when cleaning the heat gun. Never allow any liquid to get inside the tool or immerse any part of
the tool into a liquid.
ACCESSORIES
Accessories may or may not be included in your heat gun purchase. To buy additional accessories
please contact Wagner customer support (1-800-727-4023) to purchase either of the following
accessory bundles:
CRAFT ACCESSORY BUNDLE (P/N 2419823)
Includes:
- Flare nozzle
- Reector nozzle
- Silicone project mat
ELECTRONICS ACCESSORY BUNDLE (P/N 2419824)
Includes:
- Flare nozzle
- Curved nozzle
- Assorted shrink tubes (qty10)