Product Manual

SPRAYING

HOW TO SPRAY PROPERLY

• Turn the ON/OFF switch to ON (I) to turn on the turbine.

No material will spray until the trigger is activated.

• Position the spray gun perpendicular to the spray surface.

• Spray parallel to the surface with straight and full passes

at a consistent speed as illustrated, right.

• Always apply a thin coat of material on the rst pass and

allow to dry before applying a second, slightly heavier

coat.

• When spraying, always trigger the spray gun after the

spray pass has begun and release the trigger before

stopping the pass. Always keep the gun pointed squarely

at the spray surface and overlap passes by 50% to obtain

the most consistent and professional nish possible.

Frequently wipe the nozzle tip with a damp

rag when spraying to remove dried material.

PRACTICE YOUR TECHNIQUE

Practice your technique (use provided poster).

• Get closer. The spray gun should be 3-6 inches away

from the spray object.

• Full passes. Spray the material in straight and full

passes, not short waves.

• Light coats. For a ner nish, coat lightly during rst

pass, then cover completely on second pass. .

DO NOT pull the trigger when the turbine is

turned OFF. Spray material will leak from the

nozzle.

If after following the guidelines on these

two pages you are still not getting the

spray performance you need, refer to the

‘Troubleshooting’ section on page 12.

3 to 6 inches

Correct

Even coat throughout

Keep stroke smooth and at an even speed

Incorrect

Do not ex wrist while spraying.

Light coat Heavy coat Light coat

3-6”

(7-15 cm)

For an overview video of the Control Spray Double Duty, visit: