Instructions / Assembly
setUP
6
en
Material PreParation
i
Material to be sprayed may need to be strained to remove any impurities in the
paint which may enter and clog the system. Impurities in the paint will give poor
performance and a poor nish.
i
Latex paints and primers are not recommended to be used with this sprayer.
sPraYaBle Materials (water anD oil-BaseD)
• Sealers
• Transparent stain
• Semi-Transparent stain
• Lacquer (thinning may be necessary)
• Urethanes
• Decorative paints (thinning may be necessary)
*thinninG the Material
Before spraying, the material being used may need to be thinned with the proper solvent as specied
by the material manufacturer. Never exceed the thinning advice given by the coating manufacturer.
If thinning is necessary, use the proper solvent as specied by the material manufacturer. Never
exceed the thinning advice given by the coating manufacturer.
i
Only thin the material if absolutely necessary to improve spray performance. Optimal
spray performance should be acheived simply by adjusting the various controls on
the unit.
Do not thin with materials that have a ashpoint below 100°F (38°C).
i
For a video showing how to set up the Control Stainer, visit:
www.wagnerspraytech.com/controlstainer150