Use and Care Manual

PAGE 1
CLEANUP CLEANING NOTES READ BEFORE CLEANING YOU WILL NEED When using latex material, clean sprayer and components with warm, soapy water. For oil based material use mineral spirits. Never use mineral spirits with latex materials. NEVER use gasoline te clean sprayer. Dispose of used cleaning solution properly. Thorough cleaning and lubrication of sprayer is important to ensure proper operation after storage, If you flush your sprayer with mineral spirits, repeat Cleanup instructions using warm, soapy water.
PAGE 2
CLEANUP CONTINUED 5. Point the spray gun at the side of 2 waste container. Ground the gun against the side of a metal waste container if flushing with mineral spirits. While squeezing the trigger, turn the pressure contra! knob to 2, and turn the PRIME/SPRAY knob: to SPRAY. 6. Continue squeezing the trigger until fluid is coming out clear, You may need to get new cleaning solution, 7. Perform PB ure, page 10, 8. Remove the inlet filter by pulling If off the suction tube.