User manual

D
42
W 990 Flexio
GB
42
W 990 Flexio
13. Adjusting the Material
Volume
i
The material quantity is set
depending on the characteristics
of the material (viscosity) and the
working speed of the operator.
This setting is performed by adjusting
the material ow limiter (g. 14, 1) from 1
(minimum) to 12 (maximum).
i
We recommend starting with a
low material ow setting and then
gradually adjusting this to suit needs.
14. Setting the Amount of Air
i
Depending on the viscosity of the
material to be sprayed and the
nish of the object to be coated,
it may be advisable to vary the
amount of air. Very low viscosity
materials, such as watery glazes
do not have to be atomised with
the maximum amount of air. In this
case it is advisable to reduce the
amount of air and thus minimize
the spray vapour.
This also applies for the use of the
Detail and Corner/Reach spray
attachment (accessory).
Turn the air quantity regulator (g. 15, 1) until
the level you want is above the arrow.
thin paint

Level min to 6
thick paint

Level 6 to max
1

AIR
POWER
W
O
O
D
&
M
E
T
A
L
W
A
L
L
&
C
E
I
L
I
N
G

1