User manual

GB
22
W 450
10. Preparation of the Coating Material
i
Spray material that is at least at room temperature (e.g. diluted with warm
water) provides a better spray result.
Attention! Do not heat spray material above 40°C.
Interior wall paints can be sprayed undiluted or slightly diluted with the spray attachment
provided. Detailed information is available in the technical data sheet of the manufacturer
( Internet Download).
1.
Stir the material thoroughly and dilute it in the container as per the recommended
dilution (an agitator is recommended for stirring).
Thinning recommendation
Sprayed material
Interior wall paint (dispersions and latex paint) dilute by 0-10 %
2. If the feed rate is too low even at maximum flow setting, dilute in steps of 5 - 10 % until
the feed rate meets your requirements (observe the maximum permitted dilution as
stipulated by the manufacturer).
11. Start-up
Before connecting to the mains supply, be sure that the supply voltage is identical with
the value given on the rating plate.
•
Attach the carrying strap to the unit. (Fig. 2)
•
Unscrew the container from the spray gun.
•
Aligning suction tube. (Fig. 3)
If the suction tube is positioned correctly, the container contents can be sprayed
without almost any residue.
When spraying horizontal surfaces, turn suction tube forward. (Fig. 3 A)
When spraying objects overhead, turn suction tube back. (Fig. 3 B)
i
We recommend orienting the feed tube to the rear, to ensure optimal
coating of walls and ceilings.
•
Place the container on a paper base and pour in the prepared coating substance with
the aid of the feed hopper included in the scope of supply (Fig. 1, 18).
Screw the container tightly onto the spray gun.
•
Connect the front part with the rear part of the gun. (Fig. 5)
•
Mount the air hose (Fig. 4, a + b). Insert the air hose rmly into the connection of the
unit and the gun handle. The position of the hose is not relevant.
•
Put the machine down only on a level, clean surface. Otherwise, the gun may suck in
dust, etc.
•
Sling on the carrying strap with the unit.
•
Press the ON/OFF switch at the device.