User manual
GB
23
W 450
12. Selecting the Spray Setting (Fig. 6)
WARNING! Danger of injury! Never pull the trigger guard while adjusting
the air cap.
2 dierent spray jet shapes can be set by turning the adjustment ring (g. 6, 1)
Fig. 7 A = vertical at jet
for horizontal surfaces
Fig. 7 B = horizontal at jet
for vertical surfaces
Use the red adjustment lever to also switch between a wide (
)
and a narrow ( ) spray jet.
13. Adjusting the Material Volume (Fig. 8)
Set the material volume by turning the regulator on the trigger guard of the spray gun
- turn to the left
lower material volume
+ turn to the right
higher material volume
i
An average ow setting provides the best result for most wall paints.
14. Spray Technique
•
Cover all surfaces not to be sprayed.
•
It is advisable to test the spray gun on cardboard or a similar surface to nd the
correct setting.
Important: Start at the edge of the area to be sprayed. Start the spray movement
rst of all, and then press the trigger. Avoid interruptions within the area
to be sprayed.
The spray movement should come from the arm, not just from the wrist. This ensures
that a uniform distance is maintained between the spray gun and the spray surface
during the spray operation. Select a distance of 20-30 cm, depending on the desired
spray jet width.
Fig. 9 a: CORRECT Even distance to the object.
Fig. 9 b: INCORRECT An uneven distance will result in uneven paint application.
•
Move the spray gun evenly cross-wise or up-and-down, depending on the spray
pattern setting.