User manual

GB
28
W 450
Problem Cause Remedy
Coating material
causes "paint
tears"
•
Too much coating material
applied
•
Viscosity of coating material too
low
➞ Turn material volume
adjusting screw to the left(-)
Too much fog of
coating material
(Overspray)
•
Distance to the object too large
•
Too much coating material
applied
➞ Reduce distance
➞ Turn material volume
adjusting screw to the left(-)
Width of paint
spray cannot be
adjusted
•
Adjustment ring is not connected
to the peg on the air cap
•
Air screen is clogged up
➞ Connect adjustment ring
and peg
➞ Disassemble and clean
Paint in the
ventilating hose
•
Diaphragm soiled
•
Diaphragm defective
➞ Clean the diaphragm
➞ Replace the diaphragm
Poor covering
capacity on the
wall
•
Spray material is too cold
•
Highly absorbent surface
or paint with poor covering
capacity
•
Distance too large
➞ The material you are
spraying should be at room
temperature
➞ Cross spray (Fig. 10)
➞ Closer to the object
23. Technical Data
Technical Data
Max. viscosity: 3400 mPas
Power source: 230 V
~
, 50 Hz / 240 V
~
, 50 Hz
Power consumption: 460 W / 485 W
Atomizing output: 110 W
Max. delivery rate 230 ml/min
Double insulation:
Sound pressure level*: 72 dB (A); Uncertainty K = 4 dB
Sound pressure output*: 85 dB (A); Uncertainty K = 4 dB
Oscillation level*: < 2.5 m/s²; Uncertainty K = 1.5 m/s²
Air hose length: 1.8 m
Weight: approx. 2.0 kg
* Measured in accordance with EN 60745-1