Data Sheet

SAFETY INSTRUCTIONS
Please observe the following safety instructions before use:
× Always wear the necessary personal protective equipment („PPE“,
see safety data sheet of the device: gloves, goggles and mask).
× Never point the  uid stream at people or animals - there is a risk
of injury.
× Thoroughly read the operating instructions of the machine as well
as the safety data sheet of the material and follow the instructions
contained therein.
× Do not spray any electrical devices and equipment.
× When using  ammable liquids, the machine must be operated
outside the room where the spraying occurs (danger zone = 5 m
distance from the application area).
× If  ammable disinfectants are used, suffi cient ventilation must
be ensured. Furthermore, no warm or hot surfaces are to be
disinfected. If possible, electrical systems should be switched off
and light switch operations prevented. There is a risk of explosion!
!
HOW
CHECKLIST
ATTENTION! THE FOLLOWING POINTS MUST BE FULFILLED BEFORE YOU USE THE DEVICE.
ATTENTION! THE FOLLOWING POINTS MUST BE FULFILLED AFTER USING THE DEVICE.
J. Wagner GmbH | Otto-Lilienthal-Strasse 18 | D-88677 Markdorf
Phone: [phone] / 505 - 0 | Mail: [e-mail] | wagner-group.com
You have installed the spray device
5 m outside of the hazard zone.
Remove all electronic devices from the
area to be disinfected.
Flush the entire system thoroughly with water immediately after use or during work interruptions!
Ensure that there is no remaining disinfectant liquid in the unit after each use.
You have read all the information
provided by the manufacturer of the
material and have taken appropriate
measures against all potential risks.
You have checked that there are no
possible ignition sources such as lit
cigarettes, sparks, hot surfaces and
open electrical outlets in the work
area.
You have not modi ed the device or
gun and you are using only original
parts from WAGNER / TITAN.
You have read the operating manual
and all safety instructions and under-
stand how the device functions. Legal,
regulatory and normative require-
ments must be observed.
You have ensured there is suffi cient
natural or arti cial ventilation of the
work area.
You are wearing appropriate personal
protective equipment (PPE). Suitable
work clothes, protective goggles,
protection for your ears and gloves.
SETUP
× Tighten the connections on the device  rmly and check the seal of the
device with water before using it with disinfectant.
× Evacuate the water.
× Fill disinfectant into the hopper or place suction system directly in the
material container.
× For HVLP units:
o maximum air setting with low material setting
× For airless devices:
o Pressure setting: 70-100 bar (Control Pro Level 4)
o Nozzle selection: (recommendation 513, 311 for Control Pro )
o When using other nozzles, the application speed must be adjusted
× Apply disinfectant quickly and evenly to the surfaces according to the
material recommendations.
× Please refer to the manufacturer‘s instructions for exposure times of
the disinfectant you are using.
1.
4.
7.
2.
5.
8.
3.
6.
ATTENTION! USE ALCOHOL-BASED DISINFEC-
TANTS ONLY WITH AIRLESS SPRAYERS (E.G
CONTROLPRO / PROSPRAY / SUPERFINISH)