Technical data

13
GM 4600AC
B_02670
A
B CCC
OPERATING MANUAL
EDITION 04/2009
Part No. DOC394861
4.2.4 SPRAY GUN CONFIGURATION
Basis number GM 4600AC - A B C C C -> Key
0 3 9 4 0 2 0 - 1 1 4 1 1 -> For example: Part number
Table A: Maxi. material pression selection
1 160 bar; 16 MPa; 2320 psi
2 250 bar; 25 MPa; 3625 psi
Table B: Air cap selection
1 Suitable for low viscosity paints (red)
2 Suitable for high viscosity paints (blue)
Table CCC: AirCoat nozzle selection ACF3000
CCC = the last three digits of the article number -> 379CCC
107 1 = Spray angle x 10 = 10
0
. 07 = Diameter of bore in mm/1000 (0.007 mm)
411 4 = Spray angle x 10 = 40
0
. 11 = Diameter of bore in mm/1000 (0.011 mm)
317 3 = Spray angle x 10 = 30
0
. 17 = Diameter of bore in mm/1000 (0.017 mm)
625 6 = Spray angle x 10 = 60
0
. 25 = Diameter of bore in mm/1000 (0.025 mm)
835 8 = Spray angle x 10 = 80
0
. 35 = Diameter of bore in mm/1000 (0.035 mm)
The complete fl at-jet nozzle range is described in chapter 9.2.