Owner`s manual

6 © 2003 Wagner Spray Tech. All rights reserved.
English
Unscrew the nut and
remove the air cap and
nozzle.
Clean the container,
suction tube, air cap
and nozzle with a
cleaning brush and the
appropriate cleaning
solution.
Never clean nozzle or air holes in the spray gun with sharp
metal objects.
MAINTENANCE
Insert a straight-slot screwdriver through one of the slots in
the rear of the turbine.
Pry the filter cover from
the turbine.
Remove the dirty filter
from the filter cover and
replace with a new one.
The smooth side of the
air filter must be placed
toward the turbine.
Secure the cover back onto the turbine.
Never operate your unit without the air filter. Dirt could be
sucked in and interfere with the function of the unit.
CAUTION
4
3
2
1
You should inspect the air filter in the turbine to see if it is
excessively dirty. If it is dirty, follow the steps below to
replace it.
CAUTION
10
9
CLEANING THE SPRAY GUN
Special cleanup instructions for use with flammable solvents:
•
Always flush spray gun preferably outside and at a hose
length from turbine.
•
Area must be free of flammable vapors.
• Cleaning area must be well-ventilated.
Turn the turbine OFF.
Trigger the spray gun so
that the material inside the
spray gun flows back into
the container.
Unscrew the container.
Empty any remaining
material back into the
material container.
Pour a small amount of
the appropriate cleaning
solution into the cup
(warm, soapy water for
latex materials; mineral
spirits for oil-based
materials). Clean cup and
properly dispose of
cleaning solution.
Pour a small amount of
the appropriate cleaning
solution into the cup.
Attach the cup to the gun,
turn on the turbine, spray
the solution through the
gun for two seconds in a
safe area. Spray again
for two seconds. Properly
dispose of remaining
cleaning solution.
T
urn turbine OFF.
Wipe the exterior of the cup and gun until clean.
8
7
6
5
4
3
2
1
WARNING
CLEANUP