Owner`s manual

Spray Techniques

Spraying Large Areas

Spraying the Outside

Edges of Corners

Spraying the Inside

Edges of Corners

Spraying Slender Work

Spray a long panel or wall in sections. Use horizontal or vertical strokes. Keep

stroke length to 3 feet. Spraying a longer pattern may cause uneven coverage

and excessive overspray. Overlap each section by 4 inches. Narrow panels are

best sprayed using vertical strokes to help prevent too much overlapping.

Hold the gun directly facing the corner edge

so that the surfaces which form the corner are

sprayed along the edge.

Spray horizontally for vertical edges,

and spray vertically for horizontal edges.

Each surface that forms the corner should be

sprayed separately. Spray one surface

vertically. Spray the other surface with short,

even, horizontal strokes. When spraying each

surface, overlap slightly into corner.

Picket fences are sprayed with single strokes,

made vertically at an angle. This motion will

cover the front and one edge. Spray the other

side of each picket at the opposite angle.

Place a piece of cardboard behind the fence

to catch overspray.

36" 4" 36" 4" 36" 4"