Owner`s manual

Mounting Models 5100, 8100 or 9100
Mounting a Turbine
on Your Cart
Attaching the
Mounting Plate
Placing the Turbine
on the Cart
23
Your cart mounting hardware includes two spring clips, four screws and a
mounting plate.
If your turbine looks like this:
you will need to use the
mounting plate only.
1. Remove the two screws and foot pads from underneath the turbine exhaust
pipe side of the turbine.
2. Insert the screws through the foot pads and mounting plate and thread
them into the housing. Tighten securely. Be sure to keep the curved edge of
the plate pointing up.
1. Insert the curved edge of the mounting plate through the slot on the front
edge of the cart base and set the unit down on the cart.
Spring Clip Screw Mounting Plate
Turbine Exhaust Pipe
Foot Pads
Screws
Mounting Plate