User guide

English

Material Preparation

Note: Material to be sprayed may need to be strained

to remove any impurities in the paint which may enter

and clog the system. Impurities in the paint will give

poor performance and a poor finish.

Note: Only thin the material if absolutely necessary

to improve spray performance. Optimal spray

performance should be acheived simply by adjusting

the various controls on the unit.

To Prepare the Material:

1. Stir the spraying material thoroughly.

2. Unscrew the cup from the nozzle.

3. After the material has been properly thinned and

strained, ll the container to desired level.

Note: Model 590 only. Use the included paper

funnels in order to more easily fill the cup.

Thinning the material:

For certain spraying situations or desired nishes,

thinning the material may be desired. It is not necessary

for most materials when used with the iSpray nozzle.

For use with the Detail Finish nozzle thinning may be

needed to acheive a ner nish. Make sure you adjust

the X-Boost™ and Material ow settings for your specic

material needs.

If thinning is necessary, use the proper solvent as

specied by the material manufacturer. Never exceed

the thinning advice given by the coating manufacturer.

FLEXiO model 590 sprayers come with a thinning

accessory that can be used to accurately thin spray

material. Refer to the included instruction sheet.

Do not thin with materials that have

a ashpoint below 70°F (21°C). The

material ashpoint should be shown on

the material container.

590