Owner`s manual

English











1. Make sure the OFF (O) switch is pressed, and plug in the power cord.

2. Place hands onto unit using one of the methods shown on the previous page.

3. Turn the switch ON (l), and place the rotating disc onto the surface you want to

prepare.



• Test the Paint Eater™ in an inconspicuous place or on a piece of scrap wood to

become accustomed to the tool.

• Hold the disk at to the surface to remove large paint chips or to feather paint edges.







• Hold the disc on its edge to remove paint chips that are more difcult to remove.

The outer edges of the disc can be used to prepare underneath lap siding.

• After a period of operation, check the disc to see if paint is sticking to the disc. Too

much paint embedded into the disk will affect performance and should be removed.

Run the disc momentarily on a concrete sidewalk or a large concrete block. This

will knock the paint loose from the disc. Make sure cleaning surface is stable and

disc is placed at onto the cleaning surface. Do not hold block used for cleaning in

your hand. Do not immerse the disc into a solvent, such as turpentine.