Manual

English
19
Cleaning the
Spray Gun
Components
Start
You will need:
• Soft bristled brush
• Multi-Purpose Oil
• Warm, soapy water if using latex material
• Mineral spirits for oil based material
• Wrench
1. Peform the Pressure
Relief Procedure, page 7.
5. Install gun lter tapered-
end rst. Reassemble
spray gun.
4. Pour a few drops of Multi-
Purpose Oil inside gun housing.
2. Pull trigger guard to separate
from lter housing and unscrew
housing using a wrench.
Note: Tighten the wrench over the
wrench ats (a).
6. Install spray tip with arrow
pointing towards front of
spray guard tip.
3. Remove lter from spray gun.
Clean spray tip and lter with soft
bristled brush and appropriate
cleaning solution.
7. Install spray tip and guard
assembly.
Move on to Long Term
Storage, page 20.
PRIME
1
54
(a)
2
6
3
7
MULTI-PURPOSE
OIL