Manual

13
English
Safety
Spraying
Troubleshooting -
Clean the Spray
Gun Filter
You will need:
• Wrench
• Warm, soapy water for latex material
• Mineral spirits for oil based materials
• Replacement spray gun lter (if
necessary)
IMPORTANT: Never clean the filter by
poking it with a sharp object.
1. Peform the Pressure Relief
Procedure, page 7.
5. Inspect the lter for
damage. Replace if any
holes or tears are found.
4. Remove the lter from the housing.
Clean with appropriate cleaning
solution (warm, soapy water for
latex materials; mineral spirits for
oil-based materials).
2. Pull trigger guard from lter
housing.
6. Replace cleaned lter, tapered end
rst, into the gun housing.
Note: It is important to place
tapered end rst to ensure proper
sprayer operation.
3. Unscrew the lter housing using a
wrench.
7. Reassemble the spray gun.
PRIME
1
54
2
6
3
7