Owner's manual
English
4
Setup
Start
Material Preparation:
can cause clogs in the pump system or roller
assembly.
Note:
contained in anything but a round, one gallon
container, you will not be able to attach the
section, page 32, to order parts that are
Roller handle rest area:
roller handle and arm when they are not in use.
Note: The roller handle should not be placed
into the handle rest area when it is attached to
is being used.
Note: During break periods, make sure that
the roller is not saturated with paint, or it will
drip and accumulate in the spatter shield.
1. Tightly place the paint can lid
on the paint can.
4. If using the extension, press
into the handle.
2. Place paint can on the base
and insert the lid tab onto the
opening on the tower.
Press the tab over the tower
the handle and attach the roller
6. If using the Smart Edge Roller
assembly
release tabs on the handle and
3. Insert the suction tube until it
can.
(a)
(b)
(c)
1
4
2
5 6
3