Owner's manual

English
8
Cleanup -
Cleaning the Unit
and Components
Start
You will need:
  
  

  
you used oil-based paints
Note: 
cleaning solution you use may vary depending

IMPORTANT: Make sure your floors and
furnishings are covered with drop cloths
during cleanup.
IMPORTANT: DO NOT SUBMERGE THE
ROLLER HANDLE INTO ANY LIQUIDS!
Note: 


your unit.
Note: 
any accessories or components.
Note: 
separate purchase. See Accessories, page 32

1. Submerge suction tube into a

solution.
 
disassemble the roller assembly*,
and thoroughly clean the roller
cover, core, and cap by hand.
If using the Smart Edge Roller,
clean the roller cover by hand. A
spray bottle with the appropriate
cleaning solution can assist in
cleaning the harder-to-reach
areas.
 
an empty bucket.
Note: The unit must be lower than the


 
solution, raise unit above roller
arm, and run motor until all

the unit.
Turn variable speed dial to 0

 

roller handle.
Remove any remaining paint with
the appropriate cleaning solution
and a damp cloth.
IMPORTANT: If you used mineral
spirits to clean your unit, you must
repeat all the steps on this page
using warm, soapy water.
3. Turn variable speed dial to 9.
Fully press and release the handle
button to run the appropriate
cleaning solution through the
hoses and roller arm.
9
1
2
1
4
2
5
3
UNIT
UNIT
ROLLER
ARM
CLEANING
SOLUTION
ROLLER
ARM
9” Roller Only:
* 
knuckle, pry and pull the

Once the cap is removed,
push the core out the
other end.
6