Specifications

172
Engine & Steering Controls
Seattle: [phone] Fax: [phone] Call Toll Free: [phone] 8-5 M-F 9-1 Sat.
Website: http://www.seamar.com email: [e-mail]
How to measure for control cable installation
For initial installations, measure the distances A and B along an
unobstructed path to the throttle and/or clutch connection. Add A and
B together then round up to the nearest whole foot and that is the
recommended length. Cable bends for most cables should not have less
than an 8" radius. Cable bends using Supreme Cables can be as low
as 4". Care should be taken to avoid unnecessary cable bends because
each one adds to a cable's inefficiency.
For outboard applications it is necessary to add an additional four feet
for the loop that allows unrestricted engine movement.
For replacement cable installations simply remove the cable from the
boat and measure the cable as indicated below. The length will be the
proper replacement length.
To order, specify the length in inches and round up to the nearest whole
foot. Other connection kits or hardware may be necessary. See the
corresponding section in this catalog.