User's Manual

GB
19
W 660
Air nozzle
The air nozzle can be used to remove dirt and to rapidly inflate leisure articles such as
airbeds, etc. (Fig. 14).
CAUTION!
● Wear a protective mask. Fine dust particles can enter the respiratory organs.
● Do not overload the unit! Relief openings (Fig. 14, 1) may not
be blocked.
● Do not operate the air nozzle unintentionally. Check the air pressure in the
object constantly. Avoid damage by removing the air nozzle at an early stage.
Important Note regarding Product Liability!
Due to an EC ordinance in effect since 01.01.1990, the manufacturer is liable for his
product only if all parts originate from or were approved by the manufacturer and the
devices are assembled and operated correctly.
The use of other accessories and spare parts can partially or completely invalidate the
liability.
Correction of Malfunctions
Problem Cause Remedy
No coating material emerges from Nozzle clogged Clean
the nozzle Material volume setting turned too far to
the left (-) Turn to the right (+)
No pressure build-up in container Tighten container
Container empty Refill
Feed tube loose Insert
Feed tube clogged Clean
Coating material drips from the Coating material build-up on air cap and
nozzle nozzle Clean
Nozzle loose union nut tighten
Nozzle seal worn Change
Nozzle worn Change
Atomisation too coarse Material volume too large Turn material volume adjusting
Material volume adjusting screw turned too screw to the left (-)
far to the right (+)
Nozzle contaminated Clean
Viscosity of coating material too high Check viscosity
Too little pressure build-up in container Tighten container
Air filter heavily soiled Change
Spray jet pulsates Coating material in container running out Refill
Nozzle seal worn Replace
Air filter heavily soiled Change
Coating material causes Too much coating material applied Turn material volume adjusting
"paint tears" screw to the left (-)
Viscosity of coating material too low Check viscosity
Too much fog of coating material Distance to the object too large Reduce distance
(Overspray) Too much coating material applied Turn material volume adjusting
screw to the left (-)