Operating instructions
GB
19
WallPerfect W 665
Assemble the parts again (see “Assembly”).14)
Assembly
The unit may only be operated with an integer diaphragm (Fig. 12 A, 16). Place the
diaphragm with the pin facing upwards on the bottom section of the valve. Also see
the marking on the gun body. Place on the valve cover and screw it closed. Place the
ventilating hose on the valve cover and on the nipple at the gun body.
Slide the nozzle seal (Item 4) with the groove (slot) facing forwards into the nozzle (Fig. 12 B).
Put the nozzle onto the gun body and nd the correct position by turning it. Put the air
cap onto the nozzle and tighten it using the union nut.
Place the container seal from below on the suction tube and slide it over the collar, while
turning the container seal slightly. Insert the suction tube with container seal in the gun
body.
Maintenance
Change the air lter if it is soiled. Use a screwdriver to lever the cover fastening from the
unit (Fig. 11, arrow). The smooth side of the air lter (Fig. 11, 1) must be placed towards
the machine. Replace the cover on the unit until it latches.
WARNING! Never operate the machine without the air lter; dirt could be sucked in
and interfere with the function of the machine.
In order to mount the gun more easily apply lubricating grease (enclosed) liberally
to the O-ring at the gun front part (Fig. 12, 18).
Spare Parts List (Fig. 12)
Pos. Name Order No.
1 Union nut 0417 471
2 Air cap 0417 470
3 Nozzle 0417 468
4 Nozzle seal 0417 465
5 WallPerfect spray attachment incl. 1800 ml. conainer 2301 734
6 Handle 2303 300
7 Air hose 2303 410
8 Carrying belt 0414 204
9 Cover 0414 302
10 Air lter 0414 700
11 Container with cover 1800 ml (only for WallPerfect
spray attachment)
2304 025
12 Suction tube 0417 473
13 Container seal 0417 474
14 Ventilating hose
15 Valve cover 2304 027
16 Diaphragm
17 Feed hopper (3x) 2304 028
Lubricating grease 9892 550