Datasheet

214
2
10 20 30 40 50 60 70 80 90 100 105
0
5
10
15
20
2-, 4-, 6-
Current-Carrying Capacity Curve
Pin spacing: 6 mm / Conductor size 1.5 mm
2
“f-st”
Based on: EN 60512-5-2 / Reduction factor: 1
Current in A
Ambient operating temperature in °C
Conductor rated current
pole
Additional approvals and corresponding ratings can be found at www.wago.com. For additional technical information, see Section 13.
SMD PCB Terminal Blocks with Push-Buttons, 1.5 mm
2
Pin Spacing: 6 mm
2061 Series
Technical data:
Pole No.
1 pole
2 and 3 pole
Ratings per
IEC/EN 60664-1 IEC/EN 60664-1
Overvoltage category
III III II III III II
Pollution degree
3 2 2 3 2 2
Rated voltage
250 V 320 V 630 V 250 V 320 V 630 V
Rated surge voltage
4 kV 4 kV 4 kV 4 kV 4 kV 4 kV
Nominal current
17.5A 17.5A 17.5A 17.5A 17.5A 17.5A
Approvals per UL UL
Use group UL 1059 B C D B C D
Rated voltage 600 V – 600 V 600 V – 600 V
Nominal current UL 10 A – 5 A 10 A – 10 A
Material data:
Material group I
Insulating material Glass-fi ber-reinforced polyphthalamide (PPA GF)
Flammability class per UL 94 V0
Lower/Upper limit temperature -60°C / +105°C
Contact material Copper alloy
Contact plating tin-plated
Conductor data:
Connection technology Push-in CAGE CLAMP
®
Conductor size: solid 0.5 … 1.5 mm
2
Conductor size: fi ne-stranded 0.5 … 1.5 mm
2
Conductor size: fi ne-stranded 0.5 … 0.75 mm
2
(with insulated ferrule)
Conductor size: fi ne-stranded
0.5 … 0.75 mm
2
(with uninsulated ferrule)
AWG 20 … 16
Strip length 7 … 10 mm / 0.28 … 0.39 in .
Conductor entry angle 0° to PCB
●
SMD PCB terminal blocks with Push-in CAGE CLAMP
®
and push-buttons
● Just 5.6 mm high
● Push-in termination of solid and ferruled conductors
● Push-buttons for easy connection and removal of all conductor types
● Available in tape-and-reel packaging for automated assembly
Application notes:
Suitable for lead-free, refl ow-soldering profi les acc. to DIN EN 61760-1 and IEC 60068-2-58 up to max. 260 °C peak
temperature. Due to customer specifi c variables (e.g., component confi guration and orientation, type of soldering machine,
solder paste), it is recommended that trial runs are conducted to ensure product and process compatibility under actual
manufacturing conditions.

Recommendation for stencil: Material thickness, 150 µm. Stencil layout identical to pad layout.
2061 Series accessories: Pages:
Operating tool (206-861) 218
Operating tool (2061-189) 218