Datasheet
Data sheet | Item number:2065-101/998-403
www.wago.com/2065-101/998-403
04.06.2019Page /2 4
SMD PCB terminal block with PUSH WIRE® connection technology
Push-in termination of solid conductors
Just 2.7 mm tall
Available in tape-and-reel packaging for automated assembly
Note:
Die Bemessungsdaten basieren auf dem exemplarischen Rastermaß von 6 mm.
Das Layout ist gemäß den Anforderungen der Isolationskoordination EN/IEC 60664-1 bzw. der Endgerätenormen auszulegen.
Safety information 1:
NOTE: Terminal block without insulation housing! Protection against accidental contact must be provided at voltages higher than low voltages(e.
g., SELV/PELV) for the relevant application.
Data
Electrical data
Ratings per IEC/EN 60664-1
Rated voltage (III / 3) 250 V
Rated impulse voltage (III / 3) 4 kV
Rated voltage (III / 2) 320 V
Rated impulse voltage (III / 2) 4 kV
Rated voltage (II / 2) 630 V
Rated impulse voltage (II / 2) 4 kV
Rated current 9 A
Approvals per UL 1977
Rated voltage per UL 1977 (factory wiring only) 600 V
Rated current per UL 1977 (factory wiring only) 9 A
Connection data
Connection technology
PUSH WIRE
®
Actuation type Push-in
Solid conductor 0.2 … 0.75mm²/ 24 … 18AWG
Strip length 7.5 … 9.5mm/ 0.3 … 0.37inch
Conductor entry angle to the PCB 0 °
No. of poles 1
Total number of connection points 1
Total number of potentials 1
Number of connection types 1
Number of levels 1
Leiterquerschnitte eindrähtig 0.2mm²
Geometrical Data