User Manual

16 Device Description WAGO-I/O-SYSTEM 750
750-1607 Field Side Connection 8+/8-
Manual
Version 1.0.2
Pos: 26 /Serie 750 (W AGO-I/O-SYSTEM)/Geräteb eschreibung/Ansch lüsse/Leistungsko ntakte/Feldversor gung - Überschri ft 3 @ 6\mod_1256294692864_2 1.doc @ 43664 @ 3 @ 1
3.2.2 Power Contacts/Field Supply
Pos: 27.1 /Serie 750 (W AGO-I/O-SYSTEM)/Wi chtige Erläuterungen/Si cherheitshinwei se/Vorsicht/Vorsi cht: Verletzungsgefa hr durch scharfkantig e Messerkontakte! @ 6\ mod_1256193279401_21. doc @ 43414 @ @ 1
Risk of injury due to sharp-edged male contacts!
The male contacts are sharp-edged. Handle the module carefully to prevent injury.
Pos: 27.2 /Serie 750 (W AGO-I/O-SYSTEM)/Gerä tebeschreibung/Ansc hlüsse/Leistungsko ntakte 2 LK (Messer/ Feder) @ 7\mod_126631788316 7_21.doc @ 50688 @ @ 1
The I/O module 750-1607 has 2 self-cleaning power jumper contacts that supply
and transmit power for the field side. The contacts on the left side of the I/O
module are designed as male contacts and the contacts on the right side as spring
contacts.
Table 4: Power jumper contacts
Connection Type Number Function
1 Blade contact 2
Infeed of the field
supply voltage
(U
V
and 0 V)
12
12
Figure 3: Power
jumper contacts
2 Spring contact 2
Forwarding of the
field supply voltage
(U
V
and 0 V)
Pos: 27.3 /Serie 750 (W AGO-I/O-SYSTEM)/Wi chtige Erläuterungen/Si cherheitshinwei se/Achtung/Achtun g: Maximaler Strom Leistung skontakte 10 A @ 3\mod_12 26499143500_21.doc @ 25029 @ @ 1
Do not exceed maximum current via power contacts!
The maximum current to flow through the power contacts is 10 A.
Greater currents can damage the power contacts.
When configuring the system, ensure that this current is not exceeded. If
exceeded, an additional potential feed module must be used.
Pos: 27.4 /Serie 750 (W AGO-I/O-SYSTEM)/Wi chtige Erläuterungen/Si cherheitshinwei se/Hinweis/Hin weis: Potentialeinspeise klemme für Erde einsetz en! @ 3\mod_12264990374 68_21.doc @ 25023 @ @ 1
Use potential feed module for Ground (earth)!
The I/O module has no power contacts for PE intake and transfer. Use a potential
feed module when a PE feed is needed for the subsequent I/O modules.
Pos: 28 /Dokumentati on allgemein/Glieder ungselemente/---Seitenwechsel--- @ 3\mod_1221108045078_0. doc @ 21810 @ @ 1