User Manual

24 Assembly WAGO-I/O-SYSTEM 750
750-1607 Field Side Connection 8+/8-
Manual
Version 1.0.2
Pos: 64.7 /Serie 750 (W AGO-I/O-SYSTEM)/Montier en/Geräte einfügen un d entfernen - Überschr ift 2 @ 3\mod_1231768483250_ 21.doc @ 25950 @ 2 @ 1
4.2 Inserting and Removing Devices
Pos: 64.8 /Serie 750 (W AGO-I/O-SYSTEM)/Wi chtige Erläuterungen/Si cherheitshinweise/ Gefahr/Gefahr: Vorsicht bei der Unterbrec hung von FE! @ 6\mod_1256193919 214_21.doc @ 43423 @ @ 1
Use caution when interrupting the PE!
Make sure that people or equipment are not placed at risk when removing an I/O
module and the associated PE interruption. To prevent interruptions, provide ring
feeding of the ground conductor, see section "Grounding/Ground Conductor" in
manual "System Description WAGO-I/O-SYSTEM 750".
Pos: 64.9 /Alle Serien ( Allgemeine Module)/W ichtige Erläuterungen/ Sicherheits- und sons tige Hinweise/Acht ung/Achtung: Arbei ten an Geräten nur spannungsf rei durchführ en! @ 6\mod_1256193963573_2 1.doc @ 43426 @ @ 1
Perform work on devices only if the system is de-energized!
Working on devices when the system is energized can damage the devices.
Therefore, turn off the power supply before working on the devices.
Pos: 64.10 /Serie 750 (W AGO-I/O-SYSTEM)/Montier en/Busklemme einf ügen @ 3\mod_123176972670 3_21.doc @ 25989 @ 3 @ 1
4.2.1 Inserting I/O Module
1. Position the I/O module so that the tongue and groove joints to the fieldbus
coupler/controller or to the previous or possibly subsequent I/O module are
engaged.
Figure 6: Insert I/O module
2. Press the I/O module into the assembly until the I/O module snaps into the
carrier rail.