Fieldbus Independent I/O Modules 24 V DC Power Supply 750-602 Manual Version 1.0.
ii • General Copyright © 2006 by WAGO Kontakttechnik GmbH & Co. KG All rights reserved. WAGO Kontakttechnik GmbH & Co. KG Hansastraße 27 D-32423 Minden Phone: +49 (0) 571/8 87 – 0 Fax: +49 (0) 571/8 87 – 1 69 E-Mail: info@wago.com Web: http://www.wago.com Technical Support Phone: +49 (0) 571/8 87 – 5 55 Fax: +49 (0) 571/8 87 – 85 55 E-Mail: support@wago.com Every conceivable measure has been taken to ensure the correctness and completeness of this documentation.
Content • iii Content 1 Important Comments ................................................................................. 4 1.1 Legal Principles........................................................................................ 4 1.1.1 Copyright ............................................................................................. 4 1.1.2 Personnel Qualification ....................................................................... 4 1.1.3 Intended Use .....................................
• Important Comments Legal Principles 1 Important Comments To ensure fast installation and start-up of the units described in this manual, we strongly recommend that the following information and explanations are carefully read and abided by. 1.1 Legal Principles 1.1.1 Copyright This manual is copyrighted, together with all figures and illustrations contained therein. Any use of this manual which infringes the copyright provisions stipulated herein, is not permitted.
Important Comments Symbols • 5 1.2 Symbols Danger Always abide by this information to protect persons from injury. Warning Always abide by this information to prevent damage to the device. Attention Marginal conditions must always be observed to ensure smooth operation. ESD (Electrostatic Discharge) Warning of damage to the components by electrostatic discharge. Observe the precautionary measure for handling components at risk.
• Important Comments Safety Notes 1.4 Safety Notes Warning Switch off the system prior to working on bus modules! In the event of deformed contacts, the module in question is to be replaced, as its functionality can no longer be ensured on a long-term basis. The components are not resistant against materials having seeping and insulating properties. Belonging to this group of materials is: e.g. aerosols, silicones, triglycerides (found in some hand creams).
50-602 [24 V DC Power Supply] View • 7 2 I/O Modules 2.1 System Modules 2.1.1 750-602 [24 V DC Power Supply] Supply Module DC 24 V, passive 2.1.1.1 View 13 14 A C Status voltage supply -Power jumper contacts B D Data contacts + + - - Supply for power jumper contacts 24 V 0V 750-602 Power jumper contacts Fig. 2.1.1-1: Supply Module 750-602 2.1.1.2 g060200e Description The supply module 750-602 provides electrically isolated DC 24 V field side power to the downstream modules.
• 750-602 [24 V DC Power Supply] Display Elements Warning The maximum current of the supply module is 10 A. When configuring the system it is important not to exceed the maximum/sum current. However, if such a case should occur, another supply module must be added. The supply module 750-602 can be used with all couplers/controllers of the WAGO-I/O-SYSTEM 750. Attention The supplementary power supply regulations (chapter 2.1.1.
750-602 [24 V DC Power Supply] Technical Data 2.1.1.5 • 9 Technical Data Module Specific Data Voltage via power jumper contacts DC 24 V (-25 % ... + 30 %) Current via power jumper contacts max. 10 A Dimensions (mm) W x H x L 12 x 64* x 100 * from upper edge of 35 DIN rail Weight ca. 45 g Standards and Regulations (cf. Chapter 2.2 of the Coupler/Controller Manual) EMC-Immunity to interference (CE) acc. to EN 50082-2 (1996) EMC-Emission of interference (CE) acc.
750-602 [24 V DC Power Supply] Power supply concept 2.1.1.6 Power supply concept Supplementary power supply regulations: The overvoltage protection module 750-624, which is equipped with surge suppression for the 24 V DC field side power supply and used to filter the 24 V DC field power supply, is required for the certified operation of the supply module 750-602 in shipbuilding or offshore and onshore applications.
750-602 [24 V DC Power Supply] Power supply concept WAGO-I/O-SYSTEM 750 I/O Modules • 11
WAGO Kontakttechnik GmbH & Co. KG Postfach 2880 • D-32385 Minden Hansastraße 27 • D-32423 Minden Phone: 05 71/8 87 – 0 Fax: 05 71/8 87 – 1 69 E-Mail: info@wago.com Internet: http://www.wago.
