Data Sheet

Data sheet | Item number:759-302/000-923
WAGO-I/O-CHECK; USB-Set
www.wago.com/759-302/000-923
06.12.2018Page /1 2
Item description
WAGO-I/O-CHECK is an easy-to-use Windows application for the checking of inputs and outputs and the display of a WAGO-I/O-SYSTEM 750 node.
The software reads the configuration from the node and displays it as a graphic on the screen. The graphic can be printed together with a
configuration list as documentation.
With WAGO-I/O-CHECK it is possible to display and determine the process data of the bus modules. The field wiring, including all sensors and
actuators, can thus be checked before startup.
Application-specific settings, such as the baud rate or type of sensors, can be made with certain interface, Pt100 and thermocouple terminal blocks.
The coupler must be connected at a vacant serial or USB port of the PC using the communication cable supplied in the kit with the system to enable
communication between WAGO‐I/O‐CHECK and the coupler.
Data
System requirements
Supported operating systems Windows XP (SP3 or later)
Windows 7
Processor 1 GHz or higher, with 32 bits (x86) or 64 bits (x64)
RAM memory min. 1 GB RAM (recommended: 2 GB RAM or more)
Hard disk storage min. 150MByte
Graphics resolution min. 1024 x 786 (recommended: 1280 x 1024 or higher)