User Manual

e!DISPLAY 7300T Commissioning 73
762-300X Web Panels
Manual
Version 1.1.0
7.5.18 WBM Page “Firewall > MAC Address Filter”
Firewall
►MAC
Address
Filter
►MAC Address Filter State
►Current State
►MAC Address Filter State X1/X2
►Current State
►MAC Address Filter Whitelist
►Filter Enabled
►MAC Address
►MAC Mask
►Add New MAC Address Filter
►Filter Enabled
►MAC Address
►MAC Mask
You set the firewall configuration at ETHERNET level on this page.
The “MAC address filter whitelist” contains a default entry with the following
values:
MAC address: 00:30:DE:00:00:00
MAC mask: ff:ff:ff:00:00:00
If you activate the default entry, different WAGO devices in your network can
communicate with each other.
Enable the MAC address before filter activation!
Before you enable the MAC Address Filter, you have to enter and activate your
own MAC address in the “MAC Address Filter Whitelist”.
Otherwise you cannot access the device via the ETHERNET. This also applies to
other services that are used by your device, e.g., the IP configuration via DHCP.
If the “MAC Address Filter Whitelist” does not contain the MAC address of your
DHCP server, your device will lose its IP settings after the next refresh cycle and
is then no longer accessible.
If the “MAC Address Filter Whitelist” does not contain an entry, the activation of
the filter is prevented.
If at least one activated address is entered, you will receive an appropriate
warning before activation, which you have to acknowledge.