User Manual

e!DISPLAY 7300T Running Visualization 91
762-300X Web Panels
Manual
Version 1.1.0
Take care when operating the touch screen!
Always touch the screen at one point, i.e., do not touch multiple touch elements
at the same time. Doing so can trigger unintended actions.
Do not use pointed or sharp objects to operate the touch screen to avoid
damaging the plastic surface of the touch screen.
Only attach or disconnect the panel when all subassemblies in the system are
disconnected from power supply.
Faulty or incorrect connections can lead to irreversible damage to the
subassembly.
Fingertip operation causes the least amount of wear.
Avoid using the fingernail for operation.
A special stylus rounded, burr-free plastic tip must be used as the touch stylus.
The radius must be min. 1 mm.
8.2 Swipe Gestures
The display recognizes swipe gestures that run from the top down a bit. Put your
finger at the top of the transition of the black film to the display and drag down
slowly approx. 2 cm while applying some pressure with the finger. This approach
represents a conscious act, preventing faulty operation. A header appears at the
top that offers the following options:
• Disable display to allow cleaning
• Call up PLC list to select another controller
• Call up PLC list to subsequently call up the WBM for checking or changing
the panel configuration. You must be logged in as the Administrator.
Note buttons!
If you want to use the swipe gestures, make sure you do not hit buttons on the
visualization page as they are still active and can trigger control commands!
8.3 Brightness Control
There are various options for controlling the brightness of the display:
• Manual control: A specific value is set using two capacitive buttons on the
front. The value range is 0 … 255. Pressing the “little sun” button makes
the display 10 points darker; pressing the “large sun” button makes the
display 10 points brighter.