User Manual

e!DISPLAY 7300T Device Description 23
762-300X Web Panels
Manual
Version 1.1.0
3.4.1 “X1” and “X2” ETHERNET Interfaces
The ETHERNET interfaces are RJ-45 ports. The orange LED illuminates when
there is a LINK and the green one blinks during data transfer.
The connectors and cables meet category 5e requirements and guidelines for
ETHERNET interfaces.
The integrated 10/100Mbit ETHERNET switch supports Auto-MDI(X).
A crossover or patch cable can be used.
3.4.2 “X5” Supply Voltage
Connect the supply voltage to the X5 connector. For this, use the included 734-
103 female connector featuring three CAGE CLAMP
®
connections.
For more information about the supply voltage, see section “Device Description”
> “Technical Data”.
Table 8: X5 Pin Assignment
Pin
Description
Assignment
1
24VDC
Supply voltage: +24 VDC
2
GND
Reference potential 0V (ground)
3
FE
Functional earth
3.4.3 “X6” and “X7” USB-2.0 Interfaces
The USB 2.0 host interfaces are designed with 4-pin type A sockets. Each
interface can supply max. 500 mA.
The connectors comply with the USB 2.0 specification.
Keyboards or mice can be connected as alternative input devices or up to 2 USB
memory devices. These USB devices must be connected before power ON.
</dg_
3.4.4 “microSD” Memory Card Slot
The panel is equipped with a laterally mounted slot for microSD and microSDHC
memory cards.
microSD (max. 2 GB) and microSDHC (max. 32 GB) cards tested by WAGO can
be used.
Use only WAGO memory cards!
Proper function and performance cannot be ensured when using SD/SDHC
memory cards not approved by WAGO.