User Manual

e!DISPLAY 7300T Commissioning 51
762-300X Web Panels
Manual
Version 1.1.0
7 Commissioning
7.1 Removing the Protection Film
First remove the protection film from the touch screen. This film is not intended
for permanent use but only for mounting resp. connecting works.
7.2 Switching ON
The panel does not have an ON/OFF switch and is switched on together with
your machine resp. system.
At commissioning or if set, at each switching ON, following device startup you are
prompted to calibrate the screen. For this, touch the calibration points on the
screen shown successively. The calibration process is skipped if you remain
inactive for 20 seconds.
After booting the system, you are automatically taken to the WBM, PLC list or a
selected controller depending on the settings. You can interrupt the sequence
and arrive at a selection menu if you interrupt the countdown shown by touching
the screen.
7.3 Log-in
Before the WBM interface can be displayed, you are prompted to log in with a
user name and password. If starting the WBM for the first time, you have to use
the initial password. The password for “admin” is “wago”. Change the initial
password after logging in for the first time. See also section 4 “Function
Description” > “Network” and section 7 “Commissioning” > “Configuring in the
Web-Based Management (WBM)” > “WBM page ‘Administration>Users’”.
7.4 Using the Setup Wizard
At commissioning, a step-by-step wizard supports you during setup. In five steps,
you are prompted to make some basic settings to ensure the general operation of
your machine resp. system.
You can change any settings made later. To do so, launch the setup wizard
again from the function menu or go to individual settings via the WBM navigation
menu.