User Manual

WAGO PERSPECTO® 762 Commissioning 31
762-3150/000-003 CP 150 XGA TV CAN
Manual
Version 1.0.2
6.2 IP Address of the Device
6.2.1 General
The device can be programmed using WAGO-I/O-PRO / CODESYS.
Therefore, a TCP/IP connection is required. An IP address must be assigned to
the device after switching it on for the first time.
The WAGO Control Center installed on the device is used to assign the IP
address by default (observe "Setting the IP Address" section).
The device can either draw its IP address from a DHCP server on the network or
the device can be assigned a fixed IP address.
The current IP address can be queried by double-clicking on the network icon in
the system tray in the task bar.
DHCP / fixed IP address
The device must be connected to a network to change the IP address from
DHCP to a fixed IP address.
6.2.2 Setting the IP Address
The WAGO Control Center is used to set the IP address. Call up the WAGO
Control Center from the Start menu:
Start > Programs > Utilities > WAGO Control Center
1. Click the Advanced tab and then on the [LAN] button.
2. In the "Adapter Settings", click on the IP Address tab.
3. Enter the desired IP address and click [OK] to confirm.