User Manual

158 Commissioning Touch Panel Standard Line
762-4xxx TP 600
Manual
Version 1.3.0
8.7.3.2.1 “IP Configuration” Group
Table 130: WBM “TCP/IP Configuration” Page – “IP Configuration” Group
Parameter
Explanation
IP Source
Here you can specify whether to use a static or
dynamic IP address.
Static IP
Static IP addressing
DHCP
Dynamic IP addressing
BootP
Dynamic IP addressing
IP Address
Enter a static IP address here. This is enabled if
“Static IP” is enabled in the Configuration Type
field.
Subnet Mask
Enter the subnet mask here. This is enabled if
“Static IP” is enabled in the Configuration Type
field.
Click the [Submit] button to apply a change. The change takes effect
immediately.
8.7.3.2.2 “DNS Service” Group
Table 131: WBM “TCP/IP Configuration” Page – “DNS Server” Group
Parameters
Explanation
New Server IP
Add additional DNS addresses.
You can enter 10 addresses.
Manually Assigned
The addresses of the defined DNS servers are
displayed. If no server has been entered, “no DNS
Server configured” is displayed.
Assigned by DHCP
The DNS servers assigned if necessary by DHCP
(or BootP) are displayed. If no DNS server has been
assigned by DHCP (or BootP), “no DNS Server
assigned by DHCP” is displayed.
Click on [Delete] to delete an existing assignment. The change is effective
immediately.
Click on [Add] to accept a new assignment. The change is effective immediately.
8.7.3.3 “Ethernet Configuration” Page
The settings for Ethernet are located on this page.