User Manual

166 Commissioning Touch Panel Standard Line
762-4xxx TP 600
Manual
Version 1.3.0
8.7.3.6.3 “Local Time and Date” Group
Table 142: WBM “Clock” Page – “Local Time and Date” Group
Parameter
Explanation
Local Date
Set the date here.
Local Time
Set the local time here.
Click the [Submit] button to apply a change. The change takes effect
immediately.
</dg_
8.7.3.7 “Create Bootable Image” Page
You can create a bootable image on this page.
8.7.3.7.1 "Create Bootable Image from Active Partition (<Active Partition>"
Group
The active partition that boot-up was performed from is displayed in brackets in
the heading.
Table 143: WBM “Create Bootable Image” page – “Create bootable image from active partition”
Group
Parameters
Explanation
Active Partition
The possible destination partition that an image will
be saved to is displayed.
Destination
Depending on which medium has been booted, the
following destination is available for selection after
boot-up for the image to be generated:
System was booted
from
Target partition for
“bootable image”
Memory Card

Internal Flash
Internal memory

Memory Card
Once the destination has been determined and output, it is then checked and the
results of this check are displayed below the settings:
- Free space on target device:
If the available memory space is less than 5% a warning is displayed. You
can still start the copy process despite the warning. If the available space is
definitively too low, a corresponding message is displayed and copying
cannot be started.
- Device being used by CODESYS:
If the device is being used by CODESYS a warning is displayed. Although it
is not recommended, you can still start the copying procedure despite this
warning.
Click [Start Copy] to start the copying procedure. If the outcome of the test is
positive, copying begins immediately. If errors have been detected, a
corresponding message is displayed and copying is not started. If warnings have