User Manual

170 Commissioning Touch Panel Standard Line
762-4xxx TP 600
Manual
Version 1.3.0
8.7.3.11 “e!RUNTIME” Group
Table 153: WBM “Configuration of CODESYS Services” Page – “e!RUNTIME Webserver” Group
Parameters
Explanation
e!RUNTIME State
This displays the status of the e!RUNTIME system
(enabled/disabled).
Webserver enabled
Enable or disable the Webserver for the
e!RUNTIME web visualization.
Port authentication enabled
Enter here whether a login is required for connecting
to the device. The user name is “admin” and the
password is specified under “General
Configuration”.
Click [Submit] to apply change. The change is effective immediately.
8.7.3.11.1 “Configuration of DNS Service” Page
The settings for the DNS service are shown on this page.
8.7.3.12 “DNS Service” Group
Table 154: WBM “Configuration of DNS Service” Page – “DNS Service” Group
Parameter
Explanation
Service active
You can enable/disable the DNS server service
here.
Mode
Select here the operating mode of the DNS server:
Proxy
Requests are buffered to optimize
throughput.
Relay
All requests are routed directly.
Static Hosts
This displays the static assignments of IP addresses
to names. If no assignment was defined, “No static
hosts configured” is displayed.
Add Static host
Below you can enter static IP addresses and host
names.
IP Address
Enter here a new static assignment, e.g.,
“192.168.1.20”.
You can enter 10 assignments.
Hostname
Enter here a host name
Click on [Submit] to accept the changes. The changes will be effective
immediately.
Click on [Add] to accept a new assignment. The change is effective immediately.
Click on [Delete] to delete an existing assignment. The change is effective
immediately.