User Manual

102 Commissioning Touch Panel Standard Line
762-4xxx TP 600
Manual
Version 1.3.0
8.6.1.9.5 “Port Forwarding” Group
Each entry has its own area in the display.
Table 65: WBM “Routing” Page – “Port Forwarding” Group
Parameter
Explanation
Enabled
Specify here whether port forwarding should be
used.
Disabled
Port forwarding is not used.
Enabled
Port forwarding is used.
Interface
You can select the specified name of a network
interface here. Alternatively, selecting “other” allows
you to specify any network interface name.
Port
Enter the port here on which the controller receives
network data packets that are to be forwarded.
Protocol
Here you can select the protocol to be used for the
port forwarding. The options are TCP, UDP or both
protocols.
Destination Address
Specify the network address of the destination
device here. This address replaces the original
destination address of the network data packet.
Destination Port
Specify the port number of the destination device
here. This value replaces the original “Destination
Port” of the network data packet.
Click the [Submit] button to apply the changes. The changes take effect
immediately.
Click the [Add] button to add a new entry. The change takes effect immediately.
Click the [Delete] button to delete an existing entry. The change takes effect
immediately.
An entry is only transferred to the system if “Routing enabled entirely” is enabled
in the “General Routing Configuration” group. This allows you to configure a
default setting that is not applied until the general switch-on.