User Manual

Touch Panel Standard Line Commissioning 169
762-4xxx TP 600
Manual
Version 1.3.0
8.7.3.9.1 “NTP Client Configuration” Group
Table 151: WBM “Configuration of NTP Client” Page – “NTP Client Configuration” Group
Parameters
Explanation
Service enabled
Enable/disabled time update.
Update interval (sec)
Specify here the update interval of the time server.
Time Server n
Enter here the IP addresses of up to 4 time servers.
Time server No. 1 is requested first of all. If no data
is accessible via this server, time server No. 2 is
requested etc.
Additionally assigned
(DHCP)
The NTP servers assigned if necessary by DHCP
(or BootP) are displayed. If no NTP server has been
assigned by DHCP (or BootP), “none” is displayed.
Click the [Submit] button to apply the changes. The changes are effective
immediately.
8.7.3.10 “NTP Single Request” Group
To update the time immediately, irrespective of the update interval, click [Update
Time Now].
8.7.3.10.1 “Configuration of PLC Runtime Services” Page
The settings for various services of the enabled runtime system are shown on
this page.
8.7.3.10.2 “General Configuration” Group
Table 152: WBM “Configuration of PLC Runtime Services” Page – “General Configuration” Group
Parameters
Explanation
Port Authentication
Password
Enter the new password for port authentication.
Confirm Password
Enter the new password again for confirmation.
Click [Submit] to apply change. The change is effective immediately.