User Manual

190 Visualization Touch Panel Standard Line
762-4xxx TP 600
Manual
Version 1.3.0
9.2 Swipe Gestures
The display recognizes swipe gestures that run from the top down a bit. Put your
finger at the top of the transition of the black film to the display and drag down
slowly approx. 2 cm while applying some pressure with the finger. This approach
represents a conscious act, preventing faulty operation. A header appears at the
top that offers the following options:
• Call up WBM
• Call up “PLC list”/”Browser Favorites” to select another controller
• Call up “PLC list”/”Browser Favorites” to subsequently call up the WBM for
checking or changing the panel configuration. You must be logged in as the
Administrator
• Call up visualization
• Disable display to allow cleaning
Note buttons!
If you want to use the swipe gestures, make sure you do not hit buttons on the
visualization page as they are still active and can trigger control commands!
9.3 Screensaver
A screensaver can be set up and configured in the Web-Based Management.
There are 5 different modes:
• Image: The WAGO logo is displayed.
• Text: A freely selectable text is displayed.
• Time: The actual time is displayed.
• Backlight: The brightness is reduced to the screensaver brightness and the
WAGO logo displayed.
• Screen care: For screen care, all pixels are inverted for a few milliseconds
(not visible).
The screensaver is disabled as soon as the motion sensor registers a gesture.
9.4 Brightness Control
The brightness of the display can be adjusted manually: