User Manual

28 Properties Touch Panel Standard Line
762-4xxx TP 600
Manual
Version 1.3.0
4.1.2 Other Views of the PIO1 Hardware
On the back there are four M4 threaded holes for VESA mounting, four fastening
clips, one grounding screw or lead and the device labeling. For details, see
section “Mounting” and “Properties” > “Labeling.”
The connectors are located on the bottom. For details, see section “Properties” >
“Connectors.”
The operating mode switch with the settings RESET-STOP-RUN, the “CFG/RST”
button, the “SYS, RUN, CAN, H11, H22” LEDs and the “µSD” memory card slot
are located on the left side.
For details, see section “Properties” > “Connectors”
> “Display Elements” and > “Operating Elements”.
When the hardware is installed, the above-named function elements are not
accessible from the front.
Figure 3: Other PIO1 Views (Example of 762-4104)
4.1.3 Other Views of the PIO2 Hardware
On the back there are four M4 threaded holes for VESA mounting, four fastening
clips, one grounding screw or lead and the device labeling. For details, see
section “Mounting” and “Properties” > “Labeling.”