User Manual

100 Commissioning Touch Panel Standard Line
762-4xxx TP 600
Manual
Version 1.3.0
8.6.1.9.2 “Static Routes” Group
Each configured static route has its own area in the display.
To maintain compatibility with earlier firmware versions, at least two routing
entries always exist. These can be disabled, but not removed. If a route is either
removed or disabled, it is no longer entered in the system.
Table 63: WBM “Routing” Page – “Static Routes“ Group
Parameter
Explanation
Enabled
Specify here whether the selected route should be
used.
Disabled
The route is not used.
Enabled
The route is used.
Destination Address
Specify here whether any network devices or only a
specific network device or device pool should be
accessible.
default
Any network devices can be
reached.
Network address
Only a specific network device
or device from the specified
address pool can be reached.
Destination Mask
Enter the subnet mask of the device here.
If “default” is entered for Destination Address, the
value “0.0.0.0” must be entered here.
Gateway Address
Enter the address of the gateway here.
Gateway Metric
Set the number used as the metric here.
When there are multiple routes with the same
destination address and destination mask, the
metric specifies the gateway to which network data
packets are first sent. Priority is given to routes with
a lower value for the metric. The default value for
the metric is 20.
The lowest value is 0.
The highest value is 2³²−1 = 4,294,967,295.
Click the [Submit] button to apply the changes. The changes take effect
immediately.
To add a new route, click the [Add] button. The change takes effect immediately.
Click the [Delete] button to delete an existing route. The change takes effect
immediately.