User Manual

Touch Panel Standard Line Commissioning 149
762-4xxx TP 600
Manual
Version 1.3.0
8.6.1.39 “Advanced Intrusion Detection Environment (AIDE) Page”
The network security settings are available on the “Advanced Intrusion Detection
Environment (AIDE)” page.
8.6.1.39.1 “Run AIDE check at startup” Group
Table 123: “Advanced Intrusion Detection Environment (AIDE) WBM page” – “Run AIDE check at
startup” Group
Parameter
Explanation
Service active
Here, you can activate/deactivate the “AIDE check”
when the controller is started.
Click the [Submit] button to apply the changes. The changes only take effect
when the controller restarts.
8.6.1.39.2 “Control AIDE and show log” Group
Table 124: “Advanced Intrusion Detection Environment (AIDE)” WBM page – “Control AIDE and
show log” Group
Parameter
Explanation
Select Action
Select here the action to be executed.
readlog
The log data are displayed.
init
The database is initialized and filled with
the current values.
check
The current values are compared against
the values stored in the database.
update
The current values are compared with the
values stored in the database and the
database then updated.
Read all notifications
Activate display of all messages.
Read only the last n
Activate display of only the last n messages. You
also specify the number of messages to be
displayed.
Automatic refresh cycle
(sec)
Select the check box to enable cyclic refresh.
Enter the cycle time in seconds in which a cyclic
refresh is performed. The label of the button
(“Refresh”/“Stop”) changes depending on status.
To refresh the display or to enable cyclic refresh, click the [Refresh] button. The
button is only visible if cyclic refresh is enabled and has not yet started.
To stop cyclic refresh again, click the [Stop] button. The button is only visible if
cyclic refresh is enabled.
The cyclical update is performed for as long as the “Advanced Intrusion Detection
Environment (AIDE)” page is opened. If you change the WBM page, the update
is stopped until you call up the “Advanced Intrusion Detection Environment
(AIDE)” page again.