User Manual

Touch Panel Standard Line Commissioning 167
762-4xxx TP 600
Manual
Version 1.3.0
been issued, these are displayed again and you must then confirm that you still
wish to continue.
8.7.3.8 “Network Services” Page
The settings for the different services are located on this page.
Close any ports and services that you do not need!
Unauthorized persons may gain access to your automation system through open
ports.
To reduce the risk of cyber attacks and, thus, enhance your cyber security, close
all ports and services in the control components (e.g., Port 6626 for WAGO
I/O-CHECK, Port 2455 for CODESYS 2 and Port 11740 for e!COCKPIT) not
required by your application.
Only open ports and services during commissioning and/or configuration.
8.7.3.8.1 “Telnet” Group
Table 144: WBM “Network Services” Page – “Telnet” Group
Parameter
Explanation
Telnet
Enable/disable the Telnet service here.
Click the [Submit] button to apply a change. The change takes effect
immediately.
8.7.3.8.2 “FTP” Group
Table 145: WBM “Network Services” Page – “FTP” Group
Parameter
Explanation
FTP
Enable/disable the FTP service here.
Click the [Submit] button to apply a change. The change takes effect
immediately.
8.7.3.8.3 “FTPS” Group
Table 146: WBM “Network Services” Page – “FTPS” Group
Parameter
Explanation
FTPS
Enable/disable the FTPS service here.
Click the [Submit] button to apply a change. The change takes effect
immediately.