User Manual

Touch Panel Advanced Line Commissioning 149
762-5xxx/8000-000x TP 600
Manual
Version 1.3.0
8.6.3 “Configuration” Tab
8.6.3.1 “General PLC Runtime Configuration” Page
The settings for the boot project created with the programming software are given
on this page and the settings for the web visualization created in the runtime
system.
8.6.3.1.1 “General PLC Runtime Configuration” Group
Table 118: WBM “General PLC Runtime Configuration” Page – “General PLC Runtime Configuration”
Group
Parameters
Explanation
PLC runtime version
Select here the PLC runtime system to be enabled.
None
No runtime system is enabled.
e!RUNTIME
e!RUNTIME runtime system is
enabled.
Home directory on memory
card enabled
Define if the home directory for the runtime system
should be moved to the memory card.
Disabled
The home directory is stored in the
internal memory.
Enabled
The home directory is moved to the
memory card.
All data is deleted when switching the runtime system!
The runtime system’s home directory is completely deleted when switching the
runtime system!
Insert a memory card before switching the home directory!
When moving the home directory to the memory card, insert a memory card
formatted to support file system. Only the first partition of a memory card can be
accessed at /media/sd and can be used as the home directory.
Perform a reset before switching the home directory!
Stop IEC-61131 applications in use before switching the home directory of the
runtime system.
Restore the device to its initial state using the “Reset” function. Any boot project
is deleted.
Click [Submit] to apply the change.
The runtime system change is effective immediately.