User Manual

Touch Panel Advanced Line Commissioning 81
762-5xxx/8000-000x TP 600
Manual
Version 1.3.0
8.5.3.2 “Status Information” Page
The following tables explain the parameters listed on this page:
8.5.3.2.1 “Controller Details” Group
This group displays the properties of the controller.
Table 40: WBM “Status Information” Page – “Controller Details” Group
Parameter
Explanation
Product Description
Controller identification
Order Number
Item number of the controller
License Information
Notification that the CODESYS runtime system is
available
Firmware Revision
Firmware status
8.5.3.2.2 “Network Details Xn” Group(s)
This group displays the network and interface properties of the controller.
If the switch is enabled, one group (“Network Details X1/X2”) is shown for both
connections.
If the switch is disabled, a separate group (“Network Details X1” / “Network
Details X2”) is shown for each connection.
Table 41: WBM “Status Information Page – “Network Details Xn” Group(s)
Parameter
Explanation
State
Status of the ETHERNET interface
(enabled/disabled)
Mac Address
MAC address identifies and addresses the controller
IP Address
Current IP address of the controller and (in brackets)
the reference type (static/bootp/dhcp)
Subnet Mask
Current subnet mask of the controller