User Manual

174 Commissioning Touch Panel Marine Line
762-6xxx/8000-000x TP 600
Manual
Version 1.1.0
8.7.4.4 “Firewall Configuration Xn” Group
Table 161: WBM “Interface Configuration” Page – “Firewall Configuration Xn” Group
Parameters
Explanation
Firewall enabled for
Interface
Enable or disable the firewall for the specific
interface.
ICMP echo protection
Enable or disable the “ICMP echo” protection for the
respective interface.
ICMP echo limit per second
You can specify the maximum number of “ICMP
echo bursts” per second.
“0” = “Disabled”
ICMP burst limit
You can specify the maximum number of “ICMP
echo bursts” per second.
“0” = “Disabled”
Service enabled
Telnet
Enable or disable the
firewall for the respective
service.
The services themselves
must be enabled or
disabled separately on the
“Ports and Services” page.
FTP
FTPS
HTTP
HTTPS
I/O-CHECK
PLC Runtime
PLC WebVisu –
direct link (port 8080)
SSH
TFTP
BootP/DHCP
DNS
Modbus TCP
Modbus UDP
SNMP
OPC UA
Click [Submit] to apply the change. The change is effective immediately.
</dg_
8.7.4.4.1 “Configuration of MAC Address Filter” Page
You set the firewall configuration at ETHERNET level on this page.
The “MAC Address Filter Whitelist” contains a default entry with the following
values:
MAC address: 00:30:DE:00:00:00
MAC mask: ff:ff:ff:00:00:00
If you enable the default entry, this already allows communication between
different WAGO devices in the network.