Datasheet

3
78
Termination via Push-in CAGE CLAMP
®
WINSTA
®
MIDI, 770 Series
Handling:
Variable coding Marking
Simply cut off the coding pin from the socket. Insert coding pin into plug (break first) until it engages. Marking strain relief housing via WSB quick marking system.
Tighten strain relief screw using a 2.5 mm screwdriver.
We recommend pulling the pre-latched strain relief housing over
the cable prior to termination. However, the strain relief can be
mounted at a later time as well.
To terminate fine-stranded conductors, open clamping unit via
2.5 mm screwdriver and insert stripped conductor until it hits
backstop.
Insert stripped solid conductor until it hits backstop.
To terminate fine-stranded conductors, open clamping unit via
2.5 mm screwdriver and insert stripped conductor until it hits
backstop.
Prepare strain relief housing by snapping together upper and
bottom part.
1. Strip length, outer insulation = x mm
1
2. Strip length: = 9 mm
3. Extended ground conductor = 8 mm
Preparation
Strain relief installation
Latch the strain relief housing on the plug/socket. Note the
“TOP” inscription.
To remove the conductor, actuate the clamp via 2.5 mm screw-
driver and pull out the conductor.
Termination via Push-in CAGE CLAMP
®
1 Strip length, outer insulation: 2-pole = 35 mm, 3- to 5-pole = 55 mm